Bear-archery Compound Bow 2014 Bedienungsanleitung PDF herunterladen (Seite 17)

CAM ADJUSTMENTS

Synchronized Hybrid Cam System

The Synchronized Hybrid cam has a rotating module for

draw length adjustment. All draw length adjustments can be

made without the use of a bow press. Draw length changes

are made by simply rotating the modules to the desired

position and moving the draw stop. To change draw length,

remove the socket head cap screws from the top and bottom

modules, rotate the modules to the desired positions(line up

the indicator mark on the cam with the correct draw length

indicator mark on the module), making sure to align the top

and bottom to the same setting, and reapply the screws.

Next, remove the draw stop on both the top and bottom

cam and remount it in the corresponding stop locations to

the draw length you selected. Such module draw length

adjustments will not affect peak draw weight or timing.

Modules are right and left hand specific and top and bottom

specific.

In order for the Synchronized Hybrid cam system to operate

at maximum efficiency the timing needs to be set correctly.

This means that the top and bottom cams roll over and hit

their respective draw stops at the same time. The cam timing

is set during assembly at the factory, but once the bow is

broken in, or if you change strings/cables it is possible that

the cam timing will need to be checked.

If the cam system is out of time and the top stop hits before

the bottom stop, add twists into the control cable until both

stops hit at the same time. If the cam system is out of time,

and the bottom stop hits before the top stop, take twists out

of the control cable until both stops hit at the same time.

The high quality string materials used in your Bear Bow will

exhibit very little stretch and should maintain proper timing

for extended periods under normal use.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Keine Kommentare

Bear-archery Compound Bow 2014 Bedienungsanleitung Seite 17